MediaTek Helio X10 MT6795 - MT6331/6332 Regulators

Merge series from AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>:

In an effort to give some love to the apparently forgotten MT6795 SoC,
I am upstreaming more components that are necessary to support platforms
powered by this one apart from a simple boot to serial console.

This series adds support for the regulators found in MT6331 and MT6332
main/companion PMICs.

Adding support to each driver in each subsystem is done in different
patch series as to avoid spamming uninteresting patches to maintainers.

Tested on a MT6795 Sony Xperia M5 (codename "Holly") smartphone.

1 files changed, 18 insertions, 28 deletions

diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c
index cee4c0b59f43..06aa62ce0ed1 100644
--- a/drivers/mmc/core/sd.c
+++ b/drivers/mmc/core/sd.c
@@ -949,16 +949,17 @@ int mmc_sd_setup_card(struct mmc_host *host, struct mmc_card *card,
 
 		/* Erase init depends on CSD and SSR */
 		mmc_init_erase(card);
-
-		/*
-		 * Fetch switch information from card.
-		 */
-		err = mmc_read_switch(card);
-		if (err)
-			return err;
 	}
 
 	/*
+	 * Fetch switch information from card. Note, sd3_bus_mode can change if
+	 * voltage switch outcome changes, so do this always.
+	 */
+	err = mmc_read_switch(card);
+	if (err)
+		return err;
+
+	/*
 	 * For SPI, enable CRC as appropriate.
 	 * This CRC enable is located AFTER the reading of the
 	 * card registers because some SDHC cards are not able
@@ -1480,26 +1481,15 @@ retry:
 	if (!v18_fixup_failed && !mmc_host_is_spi(host) && mmc_host_uhs(host) &&
 	    mmc_sd_card_using_v18(card) &&
 	    host->ios.signal_voltage != MMC_SIGNAL_VOLTAGE_180) {
-		/*
-		 * Re-read switch information in case it has changed since
-		 * oldcard was initialized.
-		 */
-		if (oldcard) {
-			err = mmc_read_switch(card);
-			if (err)
-				goto free_card;
-		}
-		if (mmc_sd_card_using_v18(card)) {
-			if (mmc_host_set_uhs_voltage(host) ||
-			    mmc_sd_init_uhs_card(card)) {
-				v18_fixup_failed = true;
-				mmc_power_cycle(host, ocr);
-				if (!oldcard)
-					mmc_remove_card(card);
-				goto retry;
-			}
-			goto done;
+		if (mmc_host_set_uhs_voltage(host) ||
+		    mmc_sd_init_uhs_card(card)) {
+			v18_fixup_failed = true;
+			mmc_power_cycle(host, ocr);
+			if (!oldcard)
+				mmc_remove_card(card);
+			goto retry;
 		}
+		goto cont;
 	}
 
 	/* Initialization sequence for UHS-I cards */
@@ -1534,7 +1524,7 @@ retry:
 			mmc_set_bus_width(host, MMC_BUS_WIDTH_4);
 		}
 	}
-
+cont:
 	if (!oldcard) {
 		/* Read/parse the extension registers. */
 		err = sd_read_ext_regs(card);
@@ -1566,7 +1556,7 @@ retry:
 		err = -EINVAL;
 		goto free_card;
 	}
-done:
+
 	host->card = card;
 	return 0;